WuT 57637
The connector is an SNMP based connector used to monitor and configure the WuT 57637.
About
The WuT 57637 configures I/O terminals and serial interface directly to Ethernet-TCP/IP, with only one device. This device combines the functionality of a Web-IO 2x digital with that of a serial Com-Server in a single housing.
Installation and configuration
Creation
This connector uses a Simple Network Management Protocol (SNMP) connection and needs following user information:
SNMP CONNECTION:
- IP address/host: the polling IP of the device e.g., 10.11.12.13
SNMP Settings:
- Port number: the port of the connected device, default 161
- Get community string: the community string in order to read from the device. The default value is public.
- Set community string: the community string in order to set to the device. The default value is private.
Usage
Input
This page gives you an overview about the inputs of the device.
Input Ports
This page is used to configure the ports for the different inputs.
Output
This page gives you an overview about the outputs of the device.
Output Ports
This page is used to configure the ports for the different outputs.
Network
On this page you can configure the network settings for the device. This page contains four page buttons
- System Log: Contains the settings on the system logging.
- UDP: You can set if UDP is enabled and the port for the UDP transmission
- FTP: The FTP settings for the transmission
- Mail: The settings for the mail service of the device.
Session Control
This page shows the parameters for the sessions.
Manufacturer and Diagnosis
This page shows the information on the manufacturer and the diagnosis from the errors.
Timezone
Sets the time and date for the summer and winter time.
This page contains two page buttons:
- Clock: Contains the settings for the clock that will be taken into account for the time settings.
- Time Server: Settings for the time server.
Web Interface
This page can be used to access the web interface of the device.