Xicom Technology XTD-750C K
The Xicom Technology XTD-750C K connector can be used to display and configure information regarding the related controller.
About
This protocol can be used to monitor and control the Xicom Technology XTD-750C K controller. A serial connection is used in order to successfully retrieve and configure the device's information.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | No | - | - |
Installation and configuration
Creation
Serial connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: 1200 to 57900
- Databits: 8
- Stopbits: 1
- Parity: No
- FlowControl: No
Interface connection:
- IP address/host: The polling IP of the device, e.g. 10.11.12.13.
- IP port: The port of the connected device, by default 161.
- Bus address: Range 64 to 255.
Usage
The DataMiner element has three pages: General, Amplifier and Alarm.
General
This page displays the controller's general information, such as the Amplifier Model Number, Amplifier Serial Number, Firmware Version, Temperature, etc.
Amplifier
This page contains all amplifier-related readings and settings of the controller, such as the Output Power, Attenuator, etc.
Alarm
This page contains the controller's alarm reading, with parameters such as Summary Alarm, Current Alarm Status, etc.