Xicom Technology XTRD-750C
The Xicom Technology XTRD-750C connector can be used to display and configure information regarding the related controller.
About
This protocol can be used to monitor and control the Xicom Technology XTRD-750C controller. A serial connection is used in order to successfully retrieve and configure the information of the device.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Serial connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: 1200 to 57900
- Databits: 8
- Stopbits: 1
- Parity: No
- FlowControl: No
Interface connection:
- IP address/host: The polling IP of the device, e.g., 10.11.12.13.
- IP port: The port of the connected device, by default 161.
- Bus address: Range 64 to 255.
Usage
This connector has three pages, General, Amplifier and Alarm, as well as one pop-up page, Alarm Settings.
General
This page displays the controller's general information, such as the Amplifier Model Number, Amplifier Serial Number, Firmware Version, Temperature, etc.
Amplifier
This page contains all amplifier-related readings and settings of the controller, such as the Output Power, Attenuator, etc.
Alarm
This page contains the controller's alarm reading, with parameters such as Summary Alarm, Current Alarm Status, etc.
Alarm Settings
This page contains the controller's alarm settings, with parameters such as Min/Max/Reflected Power Alarm, and Min/Max/Reflected Power Fault.