Yaesu G-800DXA
The Yaesu G-800DXA is an antenna rotator.
About
This connector uses serial communication in order to send commands to the device and receive its current status.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | GS-232B |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Serial Main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Serial Redundancy connection
This connector uses a second serial connection for redundancy purposes, which requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Usage
General
This page contains all of the parameters in the connector.
It displays the current Azimuth Angle and Elevation Angle and allows you to set the Azimuth Angle, Rotation Direction and Rotation Speed.
There are also buttons available to stop the rotation (Stop Rotation) and to stop all actions (All Stop).