Ziggo CPE WiFi Collector
The Ziggo CPE WiFi Collector is part of the Ziggo CPE setup, and works together with the IAMDB database. This connector is responsible for polling the CMs and offloading the results to a .CSV file.
About
This connector will poll all the CMs in one fast poll cycle that will poll all CMs over a 15-minute period. The polled data will be offloaded into CSV files.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | No | - | - |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: 127.0.0.1 (IP addresses will be dynamically filled in).
- Device address: Not needed.
SNMP Settings:
- Port Number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: Not needed, because the connector will not perform sets.
Note: All polled CMs will share the same settings, and all polled CMTSs will share the same settings.
Usage
CM
This page contains the CM Table and some information parameters about the provisioned modems. This table shows all modems assigned to the collector. With the Get Modems button you can retrieve the latest changes from the IAMDB database. The Reinitialize Modems button is used to reinitialize the CM Table when something went wrong with the latest changes.
Provisioning
This page shows all provisioning information. The Last Provisioning Date, Last Provisioning Request and Last Provisioning Response show information about the last provisioning. The Net Provisioning Result is the result of Modems Provisioned - (Previous number of provisioned modems + New Modems -Deleted Modems). For the Provisioning Type you can choose for Full or Incremental provisioning. If you enable Automatic Provision, the connector will provision on the specified Provision Time (24H:mm). You can always force the connector to start provisioning with the Provision button.
Thread Pool Info
This page displays the thread information.
Config
On this page, you can configure the parameters Server, Database, Username and Password to connect to the IAMDB database.
With the Data Offload Folder, you can configure where you want to offload the .csv files.
Log Mac is used to show the logging from a certain MAC address assigned to the collector. Force Execute MAC can be used to immediately execute the device with the MAC address configured in the Log MAC parameter.