directOut PRODIGY.MX
This connector monitors PRODIGY.MX through its custom TCP API.
PRODIGY.MX is DirectOut's modular audio converter and signal processor, supporting multiple formats and offering flexible I/O, networked audio, and a multiformat audio matrix with a capacity of 1664 x 1664 audio channels.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. Includes all available monitoring. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | PRODIGY.MX, Build 3 (2024-01-18) |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
TCP Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (default: 5003).
How to use
This connector uses the DirectOut custom TCP communication protocol. Both when the element is started and periodically, based on a timer, a message is sent to the device to get all current status data.
To set parameters on the device, a DMA user must have access level 1.
On the Communication page, you can see the last sent command and its response.
If you wish to test a command, you can do so by setting the Outgoing Command Content parameter to the command you wish to send and then clicking the Send Command button. The Incoming Response Content parameter will display the response.
The Automatic Request Interval determines how long the system will wait before sending a new GET request if no response is received during that time.
If the timeout status is enabled, the system will consider the device unresponsive if no response is received within the defined timeout period after the request is sent. To make sure that the element correctly enters the timeout state in such a case, it is important that the default timeout settings are adjusted correctly in the element editor (under TCP/IP settings). If the device is found to be unresponsive after the element's timeout period, by default the system will wait an additional 30 seconds (the default timeout duration in the TCP/IP settings) before marking the element as in a timeout state. To minimize delays, we recommend setting this value as low as possible.
The remaining pages display status and settings data:
- General page: Contains system information data.
- Matrix page and subpages: Contains information about inputs/outputs.
- DSP page and subpage: Contains data about the input managers and sum buses.
- Status page and subpages: Contains all the status-related data.
- Settings page and subpages: Contains all the data related to settings.
- IP Config page: Contains the IP configuration parameters.
- Mirroring page: Contains the mirroring configuration parameters.
- Snapshots page: Contains data about available snapshots.