ITWatchDogs MiniGoose-II
ITWatchDogs MiniGoose-II is a climate monitor that supports up to 16 remote sensors (plus an internal temperature sensor). The main purpose of this climate monitor is to measure temperature and humidity.
About
The connector uses an SNMP connection to retrieve measurements from the remote sensors.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | v3.12.7 |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP Connection:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
This page displays general information related to the climate monitor (Name, Version, Hardware, etc.).
Sensors
This page displays temperature, humidity and air flow measurements in the Temperature Sensor Table and Air Flow Sensor Table. Each row represents the measurements from a remote sensor.
Web Interface
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.