tm stagetec systems DIO
The tm stagetec systems DIO (Dante Input Output) has a wide variety of interface and conversion options. The DIO is powered by PoE (Power over Ethernet) or runs via an external PSU. Redundancy is provided between both power sources.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | Delec Unito DIO 1.0.0.x | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 4.02.000.028 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Smart-Serial Main Connection
This connector uses a smart-serial connection and requires the following input during element creation:
SMART-SERIAL CONNECTION:
Interface connection:
- type: UDP/IP
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
HTTP connection
This connector also uses an HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: If the proxy server has to be bypassed, specify bypassproxy.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to Use
On the General page, you can configure the Polling Time, save the device configuration (under Unsaved Configuration) and view general information, such as the Uptime, Temperature, Model name and XML Configuration version.
The Unsaved Configuration parameter indicates if sets have been sent to the device without saving the configuration. Below this, the Save Config button allows you to write all changes to the disk, and the Clear Flag button allows you to set the flag to No without saving the parameters. Note that the parameter changes apply the moment the parameter is set, but they will only be "set" in active memory. This means that after a device reboot, the changes will be lost. The value of this flag is not retrieved from the device, but updated after any set and cleared when the configuration is saved (or the flag is cleared explicitly). The flag will also be cleared when the element is restarted.
After you have configured the desired polling time (by default 1 minute), you will be able to see all the data being retrieved. The General and System Information pages display generic information about the device itself. The other pages show the device information by category, such as SMA (DAC, ADC, DSP), AES, Channel Names, GPIO, etc.