Table of Contents

EPM feed

Note

Prior to DataMiner 10.1.7/10.2.0, this component is called CPE feed instead.

This feed component allows the user to make a filter selection for a particular EPM element (formerly known as CPE Manager) and EPM chain. It can be used as a filter feed for the parameter feed, so that this feed can in turn be used to display info on EPM parameters.

To configure the component:

  • From DataMiner 10.0.5 onwards:

    1. Add an element data feed. This can also be a feed from another feed component.

    2. In the Settings tab of the component, select the chain that should be filtered by the component and the chain filters that should be available.

    3. Optionally, fine-tune the component layout. In the Component > Layout tab, the following options are available:

      • The default options available for all components. See Customizing the component layout.

      • Show label: Determines whether the names of the chain filters are displayed next to the selection boxes in the component.

  • Prior to DataMiner 10.0.5:

    1. When the component is selected, go to the Settings tab in the pane on the right.

    2. In the Element box, select the EPM element.

    3. In the CPE Chain box, select the chain that should be filtered by the component

    4. Select the chain filters that should be available in the component.

    5. Optionally, fine-tune the component layout. In the Component > Layout tab, the following options are available:

      • The default options available for all components. See Customizing the component layout.

      • Show label: Determines whether the names of the chain filters are displayed next to the selection boxes in the component.

Propose changes