Table of Contents

Viewing trend information in a histogram on a view card

On the HISTOGRAM page of a view card, you can select a parameter to view its trend information in a histogram. It is also possible to save and load presets for a histogram

To view a parameter in a histogram, across the different elements in a view:

  1. On the HISTOGRAM page of a view card, select a protocol, a protocol version, and a parameter. In case of a table parameter, you should also specify an index.

    Alternatively, you can also drag an element from the Surveyor onto the graph area to immediately select the protocol of that element

  2. Click Load Histogram.

  3. Optionally, in the Advanced section at the bottom, you can specify a custom Interval width and value range (Minimum value and Maximum value), and click Apply.

To save your selections as a preset:

  1. Expand the Presets pane on the left side of the window and click the Add preset button

  2. In the Add preset window, indicate the preset type: Private, Protected or Public.

  3. Enter a name and optionally a description for the preset, and click the Add preset button at the bottom of the window.

  4. Configure the histogram in the pane at the bottom and click the Save button in the lower right corner.

    The preset will be available in the list of presets in the Presets pane on all view cards. Just click on the preset on any histogram page to load it again.

To delete a preset:

  1. Click the preset in the Presets pane in order to select it.

  2. Click the Delete button, and then click Yes in the confirmation window.

Propose changes