Ross Video General Frame
The Ross Video General Frame connector can monitor product, hardware, power, and network parameters. The device it monitors is a 2RU frame controller.
SNMP polling is used to retrieve the device information.
This connector will export different connectors based on the retrieved data. A list can be found in the section "Exported Connectors" below.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | Software version 2.50 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | See table below. |
Exported Connectors
| Exported Connector | Description |
|---|---|
| Cobalt Digital 9004 | Card 9004 Module |
| Cobalt Digital 9006 | Card 9006 Module |
| Cobalt Digital 9223 | Card 9223 Module |
| Cobalt Digital 9970-QS | Card 9970-QS Module |
| Cobalt Digital 9902-UDX | Card 9902-UDX Module |
| Cobalt Digital 9902-2UDX | Card 9902-2UDX Module |
| Cobalt Digital CDI-9363 | Card CDI-9363 Module |
| Cobalt Digital 9960 | Card 9960 Module |
| Cobalt Digital 9922 | Card 9922 Module |
Configuration
Connections
SNMP connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
- Device address: Not required.
SNMP Settings:
- Port number: 161
- Get community string: public
- Set community string: private
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to Use
General
This page contains 4 page buttons: Product, Hardware, Power, and Network:
- The Product subpage displays information about the frame: Name, Serial Number, Product, Software Version, and the Installed Slots
- The Hardware subpage displays status information: Frame Status, Safe State, Voltage, etc.
- The Power subpage displays status information: PSU1 and PSU2 Current, Frame Power, PSU1 and PSU2 Temperature, etc.
- The Network subpage displays node information: Node Name, IP Address, etc.
Slots
This page displays a table with all the active and supported slots that are connected to the device. It allows you to change the view and the name for the DVEs.
If Automatic DVE Deletion is enabled, a DVE element will be deleted when the corresponding card is removed.