SEE Telecom eAcsys NMS_X_eACSYS TX DS
This connector is exported by the parent connector SEE Telecom eAcsys NMS. It displays information regarding a transmitter module compatible with an SEE Telecom eAcsys system, and allows you to monitor and control Optical/RF features*.*
About
Product Info
| Range | Device Firmware Version |
|---|---|
| 1.0.0.x | Compatible with software version 1.5. |
| 2.0.0.x | Compatible with software version 1.5. |
Installation and configuration
Creation
This connector is automatically generated by the SEE Telecom eAcsys NMS connector.
Usage
General
This page displays the following information on the left:
- Name
- Type
- Configuration
- Serial Number
- Software Version
- Hardware Version
- BIOS Version
- Rack Number
- Slot Number
- Module Status
On the right-hand side of the page, the following parameters are displayed:
- Uptime
- Total Uptime
- Number of restarts
- Temperature
- Fan
Optical
This page displays the optical measurements from the transmitter module with the following parameters:
- Laser Bias Current
- TEC Current
- Measured Laser Output Power
- Laser Temperature
- Laser State
- TEC Status
- TEC State
- Factory Output Power
- Factory Bias Current
- Fiber Length
- Carrier Mode
- Lambda
In addition, you can normalize the values via the Normalize Values page button and refresh the displayed values with the Refresh button.
RF
This page displays the RF measurements from the transmitter module with the following parameters:
- Rx Power (in dBm and dBmV)
- Attenuator Settings (can be set by the user)
- Broadcast Equalizer (can be set by the user)
- Status
- Lock Detected
- RF Overdrive
- Narrowcast Attenuator (can be set by the user)
- Narrowcast Status
- Adjustment Mode (can be set by the user)
- APC Deviation
- APC Optimum Offset
In addition, you can use the Refresh button to refresh the displayed information.